XDC Battery Capacity Load Bank Discharge Tester

It can serve as discharge loads and realize discharge with the set constant currents by means of continuous control over discharge currents.

Description
Inquiry

XDC Battery Capacity Load Bank Discharge Tester

Introduction:

XDC Battery Capacity Load Bank Discharge Tester can serve as discharge loads and realize discharge with the set constant currents by means of continuous control over discharge currents.

When the voltage of a battery pack or a single battery is lower than the limit of voltage, or the set discharge duration or reach the set discharge capacity during discharge,

the tester will automatically stop discharge and record the real-time data of all valuable and continuous process.

The voltage information of single batteries monitored by the tester is subject to wireless repeater access that is simple, secure and accurate.

With strong software, the setup and data treatment can be done through the touch screen. The process data can be read and upload to computer for analysis.

Specifications:

Applicable battery	Lead-acid battery
Output voltage	DC10-300V
Output current	10~19V: 0~50A 19~180V: 0~100A 180~300V: 0~50A
Operating mode	Use the tester independently or with a constant-current module
Protection performance	Input terminal overvoltage protection, prompts on the LCD; Reverse polarity protection, buzzer alarm; Overcurrent protection, prompts on the LCD; 85℃ overheat protection, prompts on the LCD, buzzer alarm.
Single battery voltage acquisition	The 433RF wireless module supports a communication distance longer than 100 m and monitoring for single battery voltages of 2V, 4V, 6V and 12V. If the total voltage is not beyond the set value, each battery pack will have an unlimited single battery quantity and can monitor one to sixteen RF wireless monitoring modules at the same time. One RF wireless monitoring module can monitor 12 single batteries at the same time.
Control accuracy	Discharge current: ≤±1%; battery pack’s terminal voltage: ≤ ±0.5%; single battery voltage: ≤±0.1%
Communication with PC	RS485 interface
Data storage	2Gbit FLASH
Operating conditions
Cooling	Forced air cooling
Temperature	Operating temperature: -5~50℃; storage temperature: -40~70℃
Humidity	Relative humidity: 0~90% (40±2℃)
Noise	﹤60dB
Operating power supply
Voltage	220V AC (–20%~+30%); frequency: 45~65Hz;
Withstand voltage test	Input--casing: 2200Vdc 1min Input--output: 2200Vdc 1min Output--casing: 700Vdc 1min
Safety	Compliance line with EN610950
Wiring
AC output	Male socket in line with the applicable national standard, applicable to 1~1.5mm² cable
DC output	25mm² cable quick plug (red: positive; black: negative)